NOTICE: CircuitWriter drying times

	Your Cart is Empty
	View Cart

Support
	Knowledge Base
	Notices, Warnings & Product Dye Changes
		Dye changes in DeoxIT, DeoxIT Gold, DeoxIT Shield and DeoxIT Fader
		WARNING: Alcohol / ethanol are conductive
		MANUFACTURER DISCLAIMER
		NOTICE: CircuitWriter drying times
	Fan Club - Received

NOTICE: CircuitWriter drying times

NOTICE: CircuitWriter drying times for CW100P, CW100L-4, CW100L-32. Select link above for instructions.

NEW: A faster drying time CircuitWriter is coming in June 2011. Part numbers: CW100P-FD, CW100L-FD4, CW100L-FD32

INSTRUCTIONS:

1. PREPARE SURFACE. Remove loose scale, oil, grease and dirt from surface.
2. SHAKE WELL. Shake for at least 10 seconds. Shaker ball inside will assist mixing of materials. If necessary, clean tip with tissue or other soft cloth to remove dried material.
3. APPLY. Squeeze the pen barrel while pressing the pen tip lightly on surface. Practice on scrap piece before attempting prototype or repairs. If tip gets clogged, remove pen tip (turn clockwise) and clean.

DO NOT APPLY TO HOT SURFACE - TIP WILL MELT. MELTED TIP VOIDS WARRANTY.

4. DRY. Allow approximately 24 hours to dry at room temperature (70oF). Recommend curing 6” away from a 40 watt light bulb for 4 hours. Then let sit overnight.
5. CLEAN UP. Acetone or other suitable solvent.

JavaScript is disabled

This site requires JavaScript to work correctly, so you must first enable JavaScript in your browser to proceed.

In version 4 and higher browsers, JavaScript is enabled by default. However, it appears to be turned off in your browser.
This is often due to setting your browser Security settings too high.

Click here for help enabling JavaScript in your browser.